Saturday, March 19, 2011

Tutorial - Metal flower (Option 2)

This is an second alternative using the Sizzix Tattered Florals die instead of hand cutting the flowers as I did in the first metal flower tutorial I did.



If you enjoy making your own flower embellishments but are perhaps looking for something a little more interesting than your standard paper flower then this flower technique can offer you that and a whole lot more. Using metal will also add some interesting texture to your project.



Supplies
Sheet metal
Sizzix tattered florals die cut
Embossing folder of your choice
Embossing/Die-cutting machine
Sanding block
UTEE powder
Embossing ink
Heating tool


Step One: Using your Cuttlebug or other die-cutting machine cut 1 large, 1 medium and 1 small flower from the Sizzix tattered florals die cut set.


Step Two: Emboss your florals using any embossing folder of your choice. Using a sanding block, sand down the raised embossed images on your metal.


Step Three: Add some embossing ink to the tips of each petal and then pour some UTEE powder over. Tap off any excess powder onto a spare piece of paper which you can then use to funnel the powder back into its container.


Step Four: Using your heating tool, heat the UTEE until it begins to melt. I recommend only doing one layer as you want the grainy uneven finish for these.


Step Five: Bend each petal upwards and also pinch the top of each petal inwards creating a "v" shape as shown above. Stack the flowers starting with the largest at the bottom gluing each layer to the next as you go. Add a flower center (I used a pearl) and you're done.



These will make a lovely addition to any scrapbook layout, card or tag. Experiment with various petal shapes using your metal sheets to create different styles of flowers.

3 comments:

  1. oh my gosh......that flower is beautiful. It would look so pretty adorning some photo frames I own. Thanks for the idea.

    ReplyDelete
  2. Gorgeous!!!! This is just beautiful Wendy. Great tutorial.

    ReplyDelete
  3. wonderful tutorial Wendy! Now I NEED Tim Holtz dies! :)

    ReplyDelete